How to Elevate Your Kitchen Countertop
An elevated countertop brings a countertop to a new level of majestic appeal. Today, Im focusing on how to install an elevated design that is considered fine hardware and can enhance the finest of kitchens. Federal Brace cannot make any recommendations on specific applications, because every application is different. But they can give some general information on particular styles of countertops, which I will do in this blog.
The first thing to do before ordering the brackets is to see how many you will need. Federal Brace recommends that you use a bracket at least every 18 to 24 inches on an elevated counter application. You will need to make sure that the bracket you select works with your sub-counter arrangement.
Now that you have your support in hand you will want to set to mounting the bracket using the mounting plate at the base of the support. You can set the height of your elevated counter by moving the mounting position down from the bottom of the sub- countertop. The supports gusset will extend out and over the sub-counter.
You want to mark where to place your starter holes with a pencil. Make sure that your locations for fastening the bracket to the substructure allow for enough material for the screws to “bite into.” Take an electric drill and put an eighth inch drill bit to make the pilot holes for your fasteners. PLEASE NOTE: Make sure that you don’t drill all the way through the material the screws will fasten into.
Youre going to change up your drill so you can put in your quarter inch lag screws (or bolts), that will connect through the fascia material and into the stud or substructure. Now that the first lag bolt is connecting the brace to the material and the stud you want to make sure its level before you add additional bolts.
Once all the lag bolts are in you can use a ratchet to make sure they are snug. Dont over tighten them or you may strip out the wood. You want to make sure you use an extension when using the ratchet so you will not scratch the finished surface of the bracket.
With your brackets attached ready to support your elevated counter, you can place your counter on the support plates of the brackets. Make sure that the slab width does not extend over 4″ on either side of the plates and that the stone slab is evenly distributed over the full length of the counter. You will want to use an adhesive or chalking to fix the counter to the brackets.
With an elevated counter you will have a real showpiece in your kitchen area that can be used for serving. The spacious appeal and beauty of the elevated granite slab will enhance the look of your kitchen or even office reception area. ~ SK